![]() ![]() A plastic skid with nine legs, which can be lifted from all four sides. ![]() The classic wooden pallet, with a glove for scale. The vertical spacing of the fork holes of some pallet styles.For other uses, see Pallet (disambiguation). The distance H2 from the top surface of the fork hole to the bottom surface of the pallet cannot exceed 156mm. The height H1 of the fork hole inserted into the fork of the pallet truck under the top deck should not be less than the value in Table 1. The manufacturing tolerance of the plane dimensions given in 4.1.1 should be mm.Ġ00014.2 Vertical spacing of pallet fork holes for lifting device The above-mentioned dimensions of the plastic pallet shall be measured at a temperature of 23℃☒℃. The above-mentioned dimensions of wooden pallets should indicate their specific moisture content. The pallet plane dimensions are: 1200 mm 1000 mm and 1100 mm 1100 mm. Pallets that allow the forks of forklifts to be inserted in four directions while the forks of pallet trucks and pallet stackers are inserted in two directions. Pallets that allow the forks of forklifts, pallet trucks and pallet stackers to be inserted only from two opposite directions. Pallets that allow the forks of forklifts, pallet trucks and pallet stackers to be inserted from four directions. The vertical surface of the pallet along the length of the pallet. The vertical surface of the tray in the width direction. W: The size of the plank perpendicular to the length of the pallet. Note 2: First determine the length of the pallet, and then determine the width of the pallet. Note 1: The length of the pallet without stringer or stringer plate refers to the longer panel size. L: Refers to the panel size in the direction of the stringer or the stringer plate. The nominal plane size of the pallet length and the pallet width. The terms and definitions listed in GB/T3716, GB/T18354 and the following are applicable to this standard. This standard uses the following definition. ISO 6780-2003 International Material Handling Flat Pallets Main Dimensions and Tolerances GB/T4996 Intermodal general flat pallet test method GB/T4995 intermodal general flat pallet performance requirements For undated reference documents, the latest version is applicable to this standard. However, all parties that have reached an agreement based on this standard are encouraged to study whether the latest versions of these documents can be used. ![]() For dated reference documents, all subsequent amendments (excluding errata content) or revisions do not apply to this standard. The clauses in the following documents have become clauses of this standard after being quoted in this standard. This standard applies to general flat pallets for road, railway, waterway, and air combined transportation. The applicability of this standard to double-sided pallets used in the field may be affected. This standard also specifies requirements for tray openings, spacing, chamfers and wings. This standard specifies the main dimensions and tolerances of intermodal flat pallets with various fork loading methods, different materials, single-sided and double-sided, single-sided use and double-sided use, as well as related to pallet trucks, forklifts and other loading and unloading equipment size.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |